In order to assure that the two halves of the mold go back together precisely the way it was removed you must make registration marks. If the mold does not fit together properly, your casting will suffer imperfections and distortions. You must therefore, make certain of a precise fit into mold keys along the clay wall that you just created. An easy way to do this is to begin at Nature Crave Keto one end of the wall using a quarter and press it into the clay about a half-inch up on the wall with a twisting motion until you leave a deep indented dimple or crater. Do the same to the wall of the other shoulder. Then add a third dimple at the top of head, followed by two more halfway between the shoulder and the top of the head on both sides. When you are finished you will have created five mold keys. These indents will produce rounded protrusions on the from half of the cured plaster mold. Those front-half protrusions will lock into the rear half of the mold into a set of mold dimples on the opposite edge, so that you will have absolute registration when you molds are completed.

https://pillsfect.com/nature-crave-keto/

https://bit.ly/36MF72o